| Vehicle | 2014-2019 Toyota Highlander (3rd Gen) |
| Material | 3/16" aluminum with steel mounting brackets and extruded aluminum rails |
| Finish | Satin textured black powder coat over zinc primer |
| Load Rating | 300 lbs Dynamic / 800 lbs Static |
| Warranty | Limited Lifetime |
| Made in | USA |
Need to haul gear that doesn't fit inside your Highlander, or ready to add more cargo capacity? This roof rack gives you a solid, secure place to mount almost anything up top, so your gear has a place to go and your interior stays free for the essentials.
This rack is built from extruded aluminum rails with steel mounting brackets, giving you the strength you need without adding unnecessary weight. Milled T-nut access points run the length of the rack, so you can mount gear anywhere along the top, and easy bolt-together installation means no drilling into your roof.
Extra Mounting Hardware
Need extra hardware for more accessories? Grab the T-Slot Nut and Stud Kit (set of 12), or the T-Slot Nut and Bolt Kit and T-Slot Stud Kit.
A quick note on weight ratings:
These are a guide, not a replacement for your vehicle's manufacturer roof load limits or GVWR, so check your owner's manual first. Added weight changes handling, especially off-road or in an emergency maneuver, so load smart. As with any modification, you're responsible for how it's installed, loaded, and used.

What comes with the roof rack besides the hardware?
Every rack includes paint protection film for the contact points, anti-seize for the bolts and Ultra Black sealant for the roof mounts, so you have everything you need for a clean, protected install.
Which Highlanders does it fit?
It fits the 3rd Gen Toyota Highlander, 2014 to 2019.
Does my sunroof still work?
Yes, the sunroof tilt and slide features still work with the rack installed. It does not work with the panoramic roof.
How much weight can it carry?
It is rated for 300 lbs dynamic (while driving) and 800 lbs static (when parked), evenly distributed across the rack.
Do I need to drill?
No. The rack bolts together with no drilling into your roof, and all hardware is included.
Can I run a light bar?
Yes. Choose the 40" light bar cutout version, which includes light bar mounting brackets. The fairing fits a single-row bar up to 41.25" lens housing width, and bars up to 43.5" mounting stud width fit with trimming of the fairing. Light bar not included.
How do I mount gear?
Milled T-nut access points let you mount gear anywhere along the rack, and the T-Slot Nut and Stud Kit adds more mounting points. Cargo boxes mount right to the crossbars, since Thule box clamps pinch the crossbar and Yakima grippers wrap around it.
Do you offer black hardware?
Yes, black stainless hardware is available as an add-on.
Will the fairings scratch my paint?
We recommend paint protection film under the front and rear fairings where they touch the vehicle, so dirt and debris can't scratch the paint over time. Fairing edge trim is included.