| Vehicle | 2023+ Toyota Sequoia (3rd Gen) |
| Material | 3/16" aluminum with steel mounting brackets and extruded aluminum rails |
| Finish | Satin textured black powder coat over zinc primer |
| Load Rating | 300 lbs Dynamic / 800 lbs Static |
| Rack Dimensions | 92" x 54.5" |
| Warranty | Limited Lifetime |
| Made in | USA |
Need to haul gear that doesn't fit inside your Sequoia, or ready to add more cargo capacity? This roof rack gives you a solid, secure place to mount almost anything up top, so your gear has a place to go and your interior stays free for the essentials.
This rack is built from extruded aluminum rails with steel mounting brackets, giving you the strength you need without adding unnecessary weight. Milled T-nut access points run the length of the rack, so you can mount gear anywhere along the top, and easy bolt-together installation means no drilling into your roof.
Extra Mounting Hardware
Need extra hardware for more accessories? Grab the T-Slot Nut and Stud Kit (set of 12), or the T-Slot Nut and Bolt Kit and T-Slot Stud Kit.
A quick note on weight ratings:
These are a guide, not a replacement for your vehicle's manufacturer roof load limits or GVWR, so check your owner's manual first. Added weight changes handling, especially off-road or in an emergency maneuver, so load smart. As with any modification, you're responsible for how it's installed, loaded, and used.

What comes with the roof rack besides the hardware?
Every rack includes paint protection film for the contact points, anti-seize for the bolts and Ultra Black sealant for the roof mounts, so you have everything you need for a clean, protected install.
Which vehicles does it fit?
It fits the 2023+ 3rd Gen Toyota Sequoia.
Will my panoramic sunroof still work?
The rack installs with the panoramic sunroof, but the sunroof will not open without interference once the rack is installed.
Can I leave out the crossbars so they don't block the view out of my panoramic sunroof?
Yes, you can. If you leave the crossbars in, your panoramic sunroof still works like normal.
How much weight can it hold?
It is rated for 300 lbs dynamic (while driving) and 800 lbs static (when parked), evenly distributed.
How big is it?
The rack is 92" x 54.5".
Can I run a light bar?
Yes. The light bar cutout version includes mounting brackets and fits a single-row bar up to 41.25" lens housing width. Bars up to 43.5" mounting stud width fit after trimming the fairing.
Do I need to drill?
No. It is an easy bolt-together install with hardware and fairing edge trim included.
{{name}}