These brackets were exactly what we needed to mount our iKamper to our 100 series. The stock iKamper rails are intended to have brackets that grab and sandwich a vehicle's roof rails, but with the low profile of the Victory rack, the iKamper mounts would not work. These brackets allowed for working room between the Victory rack and the iKamper, permitting tools and hardware between the two. Mounting the iKamper would be a serious challenge without these brackets. We sourced stainless 1/4-20 hardware locally to make the connections. As the previous reviewer stated this is for a more 'permanent' install, but if removing the tent were necessary(and possible in my situation) I'd simply remove the hardware holding the Victory rails in place and lift the tent up and off the car.

I have the Victory rack on my 5th gen 4Runner and I have a Roofnest RTT. It's super hard to access the tie downs for the tent through the small side holes of the rack so I bought these thinking I'd have more room. I was wrong. It lifted the tent a little (which is nice, I still like the slim profile on the roof), but I still can't get in to tighten all the bolts down. I need to figure out a better way that doesn't involve me removing the crossbars because it's also really difficult to line up those tiny holes and bolts when you have a tent strapped to them. Sigh. The brackets themselves are good quality and easy to mount to the crossbars.

I got these to mount my Trailhead tent to my cap rack, but I found these mounts just added time to getting my tent bolted down and secured. They might be great if you don't plan on moving the tent around at all and don't a more permanent system. I will likely repurpose these and use them to mount some traction boards instead though since the mounts are really sturdy.