Overall good fit and finish, but oil changes stink
The fit and finish overall is really good on this skid. The skids seem pretty stout and they sit up about as tight as possible.
That said, I just did my first oil change, and what a mess. There is a notch cut out of the skid for the oil drain plug, and it works fine for the first 3/4 of the oil drain, but as the flow starts to slow down out of the drain, the oil starts to run down the oil pan and drip from the low point on the pan which is farther inboard. The notch is not cut far enough to catch this. So my skid plate 1 or 2 quarts of oil and was just holding it up there. I have to drop the plate to get it out now, which I am sure will be a huge mess as it sloshes around while I try to lower 50+ lbs of steel.
I would suggest not leaving the skid in place while doing an oil change unless you have a fumoto valve or you have a small funnel you can jam up between the skid and drain hole once the flow starts to slow down.













